Diablo - DSP-40 - Plug-in Loop Detector
A plug-in detector which now has 4 levels of sensitivity. The DSP-40S detector will add a new dimension of simplicity to your plug-in detector requirements. This detector has been specifically designed to handle parking, drive-through and access control applications where solid-state outputs are required for both the "Detect" and the "Fail" outputs.
Diablo - DSP-11 - Mini Detector
Diablo Controls has been listening! We now offer a complete line of simple, switchless, single output vehicle detectors available with the industry standard 11-pin base.
Diablo - DSP-06LP - Low Power Detector
The DSP-6LP low power detector has been re-designed to be used on any voltage and either polarity from 10 to 30 Volts AC or DC. This low power vehicle detector is perfect for solar powered gate installations. This detector beats all competition for current consumption. Works on all gate and access control applications that require extremely low current draw from a solar powered gate installation. The 6LP detector is " fail-secure", and should be used on free exit loops.
LMA-1800 Plug-In Loop Detector
Single channel with dual programmable solid state outputs. Printed circuit board (pcb) mounted. The DEFLECTOMETER display helps optimize the proper sensitivity setting to detect all vehicles including motorcycles. NO MORE GUESS WORK WHEN SETTING SENSITIVITY OR FREQUENCY!
Diablo DSP-19 - Low Power and Mini-Loop Detector (LiftMaster Compatible)
The DSP-19 is specifically designed to be installed into a LiftMaster model CSW24 operator or other models that use the same plug-in loop detector. The very low current draw and low voltage range is ideal for solar applications.
The DSP-19 can be connected to a standard inductive loop or one of Diablo Controls mini-loops. The Diablo Controls mini-loop is a small "pipe shaped" device approximately 4-1/2" by 1" and is designed to be buried in the ground to detect vehicles. If the mini-loop feature is turned on, the detector cannot be used as a safety detector as there is no presence detection in this mode of operation. Contact Diablo Controls for more information on the mini-loop.
The DSP-19 can be used as either a safety loop or free exit loop detector. It also has the flexibility to be either "fail-safe" or "fail-secure".
The DSP-19 has a single solid-state open-drain FET output capable of sinking more than 250 milliamps.
The DSP-19 has 10 selectable sensitivity settings and uses a 6-position DIP switch to configure the detector. This includes the Diablo Controls mini-loop selection as well as sensitivity boost, extended presence and fail-safe/fail-secure operation. This makes the DSP-19 very flexible and versatile for those installations that need a little more than a standard detector.
Diablo DSP-22-1 Single Channel Vehicle Detector (DoorKing Compatible)
The DSP-22-1 detector is designed to be a low power, direct replacement for the existing DoorKing Model 9410 single channel inductive loop vehicle detectors for the parking and access control industries. The DSP-22-1 loop detector plugs into the loop detector ports on the DoorKing operator control board.
The DSP-22-1 operates as a single channel detector. The DSP-22-1 is a detector that uses advanced channel scanning technology to provide superior noise tolerance.
The DSP-22-1 always operates in the Fail-safe mode of operation.
DKS is a registered trademark of DoorKing Systems.
